Door damper V 1600 for sliding doors
With a special mounting bracket for sliding doors
Characteristics
- Detailed information on the door damper V 1600 can be found here
- The stainless steel mounting bracket allows its use on sliding doors
- The recommended closing force is usually 20 N, as otherwise the force required to open the door would be too high
Product details
Operation
Dimensions
All dimensions in mm
Mounting bracket for sliding doors
Part no. 203037
Door damper V 1600
Dimension of X with
- hook 1009 for flush doors: X = 59
- hook 1013 for overlapping doors: X = 78
- hook 1011 for recessed doors: X = 39
Installation
Installation notes
The mounting bracket for the V 1600 is screwed approx. 85 mm below the door frame on the door near its closing edge. The distance to the closing edge depends on whether the closed door just rests against the frame or enters in a recess.
Fold out the base plate of the door damper and fix it to the bracket. Then hinge down the body of the door damper until it clips to its base plate.
To mount the hook, bend the roller lever of the door damper. Firstly, fix the hook to the frame only by using the two oblong holes so that it’s in line with the door damper and the rubber roller just touches its front edge when closing. After having adjusted the hook on the correct position, you can also fix it through the two normal holes.
Installation instructions
Application pictures
Order information
Order Information
| Description | Part No. |
|---|---|
| Mounting bracket sliding doors for V 1600, unequal angle (114 x 35 x 40 x 3 mm), stainless steel, with fastening material | 203037 |
